Mercury 150 EFI Service Manual page 513

RIGHT HAND NON-RATCHETING
5. Install cross pin retaining spring onto sliding clutch as follows:
IMPORTANT: DO NOT over-stretch retaining spring when installing onto sliding
clutch.
6. Spirally wrap spring into groove on sliding clutch.
7. Place gear housing in a soft jaw vise with the driveshaft in a vertical position.
8. Coat cam pocket of cam follower with 2-4-C with Teflon Marine Lubricant.
9. Place shift cam into cam pocket of cam follower with numbered side of cam facing up.
10. With shift cam positioned as shown, insert propeller shaft thru forward gear until shaft
bottoms out.
a
b
b
c
a -
b -
c -
d -
e -
Page 6A-40
55095
Cam Pocket
Cam Follower
Shift Cam
Shift Cam (Position as Shown)
Gear Housing
d
a
e b
51864
90-883728 JULY 2001