Engine Oil Reservoir Removal and Installation
REMOVAL
1. Disconnect the oil hoses. Plug the hoses to prevent spillage.
2. Disconnect the BLUE with BLACK STRIPE wire leads.
3. Remove three bolts securing oil tank to powerhead and remove tank.
a -
b -
c -
d -
e -
g -
h -
INSTALLATION
1. Install oil reservoir as shown.
2. Fasten the oil hoses with sta-straps.
3. Connect the BLUE with BLACK STRIPE wire leads.
4. Refill the oil system. Refer to Priming the Oil Pump.
90-883728 JULY 2001
Oil Reservoir
Bushing (3)
Rubber Grommet (3) – Insert into Holes
Decal
Bolt (3) – Torque to 170 lb. in. (19 Nm)
f -
Washer (3)
Washer
Screw (Drive Tight)
i -
Low Oil Switch (Normally Closed Circuit)
c
f
e
d
58780
OIL INJECTION
i
h
g
b
a
b
c
Page 3C-13