Mercury 150 EFI Service Manual page 215

WIRING DIAGRAMS
CALIBRATION
SPEED UNITS
KN - KPH - MPH
[SAVE]
[DOWN]
CALIBRATION
EXTERNAL SENSORS
[SKIP]
CALIBRATION
EXTERNAL SENSORS
SPEEDO SENSOR ? YES/NO
[DOWN] [SAVE]
CALIBRATION
EXTERNAL SENSORS
PADDLE WHEEL SENSOR ? YES/NO
DOWN] [SAVE]
[
CALIBRATION
EXTERNAL SENSORS
WATER TEMP SENSOR ? YES/NO
[DOWN] [SAVE]
CALIBRATION
FUEL TANK CAPACITY
CAPACITY = XX.XX
[DOWN] [SAVE]
CALIBRATION
FUEL TANK CALIBRATION
[SKIP]
CALIBRATING
EMPTY TANK
THEN PRESS PLUS (+) BUTTON
[DFLT] [SKIP]
CALIBRATING 1/4 VALUE
FILL TO X.X G.
THEN PRESS PLUS (+) BUTTON
[DFLT] [SKIP]
CALIBRATING 1/2 VALUE
FILL TO X.X G.
THEN PRESS PLUS (+) BUTTON
[DFLT] [SKIP]
CALIBRATING 3/4 VALUE
FILL TO X.X G.
THEN PRESS PLUS (+) BUTTON
[DFLT] [SKIP]
CALIBRATING FULL
FILL TANK TO FULL
THEN PRESS PLUS (+) BUTTON
[DFLT] [SKIP]
Page 2D-62
Display boat speed in KN (knots), KPH (kilometers per hour),
MPH (miles per hour). Press + or – to select setting. Press
MODE to save.
[UP]
Press MODE to skip to the next display. Press + (edit) if your
adding or deleting any external sensor to the SmartCraft Sys-
tem.
[EDIT]
Editing External Sensors
Add Yes or No for each sensor
No = not used Yes = in use
Press + or – for correct setting
Press MODE to save and advance to next sensor
[UP]
[UP]
[UP]
Add the capacity of the fuel tank. Press + or – to select.
Press MODE to save.
[UP]
This calibration sets the fuel level of the tank.
NOTE: If the fuel tank is not calibrated, fuel range cannot be
displayed
[EDIT]
Press MODE to skip to the next display. Press + (edit) to
calibrate the fuel tank.
Pressing DFLT (default) during edit will return to original value
setting
Calibrate the fuel tank as follows:
[SAVE]
1. Empty the fuel tank, Press + to save
2. Fill tank to 1/4 full, Press + to save.
3. Fill tank to 1/2 full, Press + to save
4. Fill tank to 3/4 full, Press + to save.
5. Fill tank to full, Press + to save.
[SAVE]
The fuel tank is now calibrated
[SAVE]
[SAVE]
[SAVE]
90-883728 JULY 2001