POWER TRIM
5. Remove outboard transom mounting bolts, and loosen tilt tube nut until nut is flush
with end of tilt tube thread.
6. Remove 3 screws and washers and move starboard transom bracket.
a -
b -
c -
d -
IMPORTANT: Cross pin (a) should not be reused. Replace with new cross pin.
7. Drive out cross pin, push out upper swivel pin, and remove 3 screws and washers re-
taining trim system. Remove system from outboard.
a -
b -
c -
Page 5B-20
a
a
a
a
Transom Mount Bolts (2)
Tilt Tube Nut (flush with end of thread)
Screws (3)
Washers (3)
a
a
c
c
Cross Pin
Upper Swivel Pin
Port Transom Bracket Screws and Washers (3). Remove to Release Trim
System from Outboard.
b
b
51375
b
b
51339
c d
51375
90-883728 JULY 2001