Power Trim Assembly Removal And Installation; Removal - Mercury 150 EFI Service Manual

POWER TRIM

Power Trim Assembly Removal and Installation

Removal

1. Remove clamps on transom bracket to free power trim wiring.
2. Raise outboard to full "Up" position and engage tilt lock lever.
a -
b -
Failure to support outboard as shown could result in personal injury and/or dam-
age to outboard or boat.
a -
b -
c -
IMPORTANT: Support outboard as shown above to prevent engine from tipping
when power trim retaining pin is removed.
Page 5B-18
a
a
a
Clamps
Tilt Lock Lever
a
Tilt Lock Lever
Support Tool
Retaining Clips
51377
WARNING
c
c
b
b
51346
c
c
b a
50605
90-883728 JULY 2001