Oil Reservoir Removal; Oil Reservoir Installation - Mercury 150 EFI Service Manual

FUEL INJECTION

Oil Reservoir Removal

1. Disconnect low oil sensor bullet connectors (BLUE leads).
2. Remove sta-strap securing reservoir hose to oil pump and remove hose. Plug hose
to prevent leakage.
3. Remove oil input hose to oil reservoir from check valve.
4. Remove 3 screws and remove reservoir.
a -
b -
c -
d -
e -

Oil Reservoir Installation

1. Secure oil reservoir to engine with 3 screws. Torque screws to 14 lb. ft. (19 Nm).
2. Secure oil reservoir hose to oil pump with sta-strap.
3. Secure oil input hose to check valve with sta-strap.
4. Reconnect low sensor bullet connectors.
Page 3B-56
Bullet Connectors
Reservoir Hose
Oil Input Hose
Screws
Oil Reservoir
e
c
b
a
d
58896
90-883728 JULY 2001