Transom Mounted Ride Guide Attaching Kit Installation (73770A1); Attaching Kit Installation - Mercury 150 EFI Service Manual

ATTACHMENTS / CONTROL LINKAGE
Transom Mounted Ride Guide Attaching Kit Installation
(73770A1)

Attaching Kit Installation

1. Lubricate both holes in pivot block (Figure 1) with Quicksilver 2-4-C with Teflon.
2. Place pivot block on pivot spacer and secure to transom bracket with 3/8 in. x 2-1/2
in. (9.5 mm x 63.5 mm) bolt, flat washer and locknut, as shown in Figure 1. Torque
locknut to 20 Ib. ft. (27 Nm).
a
k
d
Figure 1
a -
b -
c -
d -
e -
g -
h -
k -
Page 7-28
b
f
j
Ride-Guide Cable
Ride-Guide Yoke
Pivot Block
Pivot Spacer
15 in. (381 mm) (Centerline of Attaching Kit Pivot to Centerline of Outboard)
f - Pivot Attaching Locknut [Torque to 20 lb. ft. (27 Nm)]
Outboard Steering Arm
"Clevis Kit"
i - Ride-Guide Cable Attaching Locknut [Torque to 10 lb. ft. (13.5 Nm)]
j - Bolt [3/8 in. x 2-1/2 in. (9.5 mm x 63.5 mm)]
Flat Washer
l - Transom Bracket
c
l
e
h
i
g
90-883728 JULY 2001