Mercury 150 EFI Service Manual page 371

POWERHEAD
9. Install oil seals into lower end cap as follows:
a. Apply a thin bead of Loctite 271 to outer diameter on 2 lower end cap oil seals (a).
b. Using driver head (91-55919) press one oil seal (lip facing down) into lower end cap
c. Press second oil seal (lip facing down) until firmly seated on first oil seal. Remove
d. Lubricate oil seal lips with Quicksilver 2-4-C with Teflon.
e. Lubricate O-ring seal surface on end cap with 2 cycle oil. Install o-ring over lower end
a
a
Loctite 271
7
14 2 Cycle Outboard Oil
95 2-4-C With Teflon
10. Install oil seal into upper end cap as follows:
a. Apply a thin bead of Loctite 271 to outer diameter of upper end cap oil seal.
b. Use a suitable mandrel, press oil seal into upper end cap (lip facing down) until bot-
c. Lubricate oil seal lip with Quicksilver 2-4-C with Teflon.
d. Lubricate O-ring seal surface on end cap with Quicksilver 2-4-C with Teflon. Install
7
7
Loctite 271
95 2-4-C With Teflon
Page 4A-54
until firmly seated. Remove any excess Loctite.
any excess Loctite.
cap.
95
a - Oil Seal
tomed out on lip of end cap. Remove any excess Loctite.
O-ring on end cap.
a
95
b
a - Oil Seal
b - Lip of End Cap
c - O-Ring
7
a
b
14
95
c
51849
b - O-ring
58324
90-883728 JULY 2001