Mercury 150 EFI Service Manual page 339

POWERHEAD
8. Slide outboard shift lever into neutral position.
9. Remove locknut and flat washer securing throttle cable and remove cable.
10. Remove locknut that secures shift cable latch assembly and remove latch, flat washer,
nylon wear plate, spring and shift cable from control cable anchor bracket.
11. Disconnect input fuel line, water pressure hose and speedometer hose.
Page 4A-22
h
a - Lock Nut (Throttle
Cable)
b - Flat Washer
c - Shift Cable Latch
d - Lock Nut (Shift Cable)
e - Flat Washer (Hidden
under nut)
f - Nylon Wear Plate
b
a - Input Fuel Hose
b - Water Pressure Hose (GRAY) (Analog Gauges)
c - Speedometer Hose (BLACK) (Analog Gauges)
j
i
c
a
b
a
d
c
e
f
g
57838
g - Spring (Hidden)
h - Shift Cable
i - Anchor Bracket
j - Throttle Cable
90-883728 JULY 2001