Mercury 150 EFI Service Manual page 502

11. Place second seal on short shoulder side of seal driver with lip of seal toward shoulder.
Press seal into bearing carrier until seal driver bottoms against bearing carrier.
a -
b -
c -
12. Wipe off excess Loctite.
13. Apply a light coat of Quicksilver Super Duty Gear Lubricant onto the outside diameter
of reverse gear ball bearing.
14. Place bearing carrier over reverse gear and bearing assembly. Press bearing carrier
onto bearing.
a -
b -
15. Place O-ring over bearing carrier and position it between bearing carrier and thrust
washer.
16. Lubricate oil seals and O-ring with Quicksilver 2-4-C with Teflon Marine Lubricant.
90-883728 JULY 2001
c c
Oil Seal (Lip of Seal Up)
Oil Seal Driver
Seated
b
Mandrel
Seated
RIGHT HAND NON-RATCHETING
b
b
a a
a
a
51870
51872
Page 6A-29