Cal1 Calibration - Mercury 150 EFI Service Manual

WIRING DIAGRAMS

CAL1 Calibration

NOTE: NOT ALL SCREENS MAY APPLY TO YOUR ENGINE TYPE.
CAL1 HEADER SCREEN
1. Turn ignition key to the on position.
2. Press and hold
Release the buttons to enter Cal1 .
3. Press the
4. Press and hold
ibration screen.
Press the
NOTE: Pressing the
Cal2.
TRIM POP UP SCREEN (ON OR OFF)
If you want the power trim display screen to pop up as you trim the propulsion unit, cali-
brate as follows: With the pop up screen displayed and the number "flashing", press the
Press the
Set the trim sensor as follows:
Calibration 0.0 – The word "Trim" and down arrow should be blinking. Use the trim switch and
trim the unit to the full Down/In position. Press the
button to advance to the Calibration 10.0 setting.
Page 2D-30
Cal1 Display Calibrations:
Trim Pop up Screen (On or Off)
Trim Calibration
English or Metric Units Selection
Range Units Selection
(On or Off) Depth, Trim, Engine Temperature, Oil Pressure, Oil
Temperature, Water Pressure, Volts, Engine Hours, and Data
Simulator pages.
and
button to advance through the Cal1 calibration functions.
and
button to move to the next calibration screen.
button while in this header screen, will "transfer" you straight into
button to select 1=ON or 0=off.
button to save and move to the next function.
for 3 seconds to bring up the Cal1 calibration screen.
for 3 seconds to save changes and exit the Cal1 cal-
Trim
button to save. Press the
Trim
90-883728 JULY 2001