Starter Removal (Centrifugal Bendix); Starter Installation (Centrifugal Bendix) - Mercury 150 EFI Service Manual

Starter Removal (Centrifugal Bendix)

Disconnect battery leads from battery before removing starter.
1. Disconnect BLACK ground cable from starter.
2. Disconnect BLACK (with YELLOW sleeve) cable from starter.
3. Remove 4 bolts and upper and lower starter clamps. Lift starter from engine.
a -
b -
c -

Starter Installation (Centrifugal Bendix)

1. Slide rubber collars on starter.
2. If the removed starter was equipped with a spacer replace spacer on upper collar.
a -
3. Install starter to engine with starter clamps. Make sure that BLACK ground cable is
fastened, along with lower mounting bolts. Torque bolts to 210 lb. in. (23.5 N·m).
4. Reconnect yellow cable to positive (+) terminal on starter.
5. Reconnect BLACK ground cable to terminal on starter.
90-883728 JULY 2001
BLACK ground cable
BLACK (with YELLOW
sleeve) + 12 volt cable
Upper Mount Bolts
a
b
Rubber Collar
CAUTION
c
a
e
d
f
b
CHARGING & STARTING SYSTEM
58803
d - Lower Mount Bolts
e - Upper Clamp
f - Lower Clamp
a
11645
b - Spacer (If Equipped)
Page 2B-27