6. Install 10 flat washers,and 10 locknuts which secure powerhead to exhaust extension
plate/driveshaft housing. Torque locknuts in 3 progressive steps until secured.
7. Disconnect hoist from Lifting Eye and remove Lifting Eye from flywheel.
8. Reinstall plastic cap into center of flywheel cover.
9. Connect water hose to fitting on exhaust adaptor plate.
90-883728 JULY 2001
a
a
a -
Locknuts and Washers – Torque nuts to 20 lb. ft. (27 N m)
a -
Water Hose
b -
Fitting
a
a
a
a
b
POWERHEAD
51846
58069
Page 4A-75