Fuel Requirements; Fuel Ratings; Using Reformulated (Oxygenated) Gasoline (Usa Only); Gasoline Containing Alcohol - Mercury 6.2 Inboard MPI DTS Operation & Maintenance Manual

Table of Contents

Advertisement

Section 3 - Specifications

Fuel Requirements

Running out of fuel can damage catalyst components. Do not allow the fuel tanks to become empty during operation.
IMPORTANT: Use of improper gasoline can damage your engine. Engine damage resulting from the use of improper
gasoline is considered misuse of the engine and will not be covered under the limited warranty.

Fuel Ratings

Mercury MerCruiser engines will operate satisfactorily with any major brand of unleaded gasoline that meets the following
specifications:
USA and Canada ‑ A posted pump octane rating of 87 (R+M)/2, minimum, for all models. Premium gasoline 91 (R+M)/2
octane is also acceptable for all models. Do not use leaded gasoline.
Outside USA and Canada ‑ A posted pump octane rating of 91 RON, minimum, for all models. Premium gasoline (95 RON) is
also acceptable for all models. Do not use leaded gasoline.

Using Reformulated (Oxygenated) Gasoline (USA Only)

Reformulated gasoline is required in certain areas of the USA and is acceptable for use in your Mercury Marine engine. The
only oxygenate currently in use in the USA is alcohol (ethanol, methanol, or butanol).

Gasoline Containing Alcohol

Bu16 Butanol Fuel Blends

Fuel blends of up to 16.1% butanol (Bu16) that meet the published Mercury Marine fuel rating requirements are an acceptable
substitute for unleaded gasoline. Contact your boat manufacturer for specific recommendations on your boat's fuel system
components (fuel tanks, fuel lines, and fittings).

Methanol and Ethanol Fuel Blends

IMPORTANT: The fuel system components on your Mercury Marine engine will withstand up to 10% alcohol (methanol or
ethanol) content in the gasoline. Your boat's fuel system may not be capable of withstanding the same percentage of alcohol.
Contact your boat manufacturer for specific recommendations on your boat's fuel system components (fuel tanks, fuel lines,
and fittings).
Be aware that gasoline containing methanol or ethanol may cause increased:
Corrosion of metal parts
Deterioration of rubber or plastic parts
Fuel permeation through the rubber fuel lines
Likelihood of phase separation (water and alcohol separating from the gasoline in the fuel tank)
Fuel leakage is a fire or explosion hazard, which can cause serious injury or death. Periodically inspect all fuel system
components for leaks, softening, hardening, swelling, or corrosion, particularly after storage. Any sign of leakage or
deterioration requires replacement before further engine operation.
IMPORTANT: If you use gasoline that contains or might contain methanol or ethanol, you must increase the frequency of
inspection for leaks and abnormalities.
IMPORTANT: When operating a Mercury Marine engine on gasoline containing methanol or ethanol, do not store the gasoline
in the fuel tank for long periods. Cars normally consume these blended fuels before they can absorb enough moisture to cause
trouble; boats often sit idle long enough for phase separation to take place. Internal corrosion may occur during storage if
alcohol has washed protective oil films from internal components.

Engine Oil

For optimum engine performance and maximum protection, use the following oil:
Application
All MerCruiser engines
IMPORTANT: Lubrication requirements for catalyzed engines differ from the requirements for noncatalyzed engines. Some
marine‑grade lubricants contain high levels of phosphorus. Although these high‑phosphorus lubricants may allow acceptable
engine performance, exposure over time will damage the catalyst. Catalysts damaged by lubricants containing high levels of
phosphorus may not be covered by the MerCruiser Limited Warranty.
Page 28
Recommended Oil
Mercury/Quicksilver 25W‑40 Synthetic Blend Engine Oil, NMMA FC‑W Catalyst Compatible rated
NOTICE
WARNING
!
90-8M0119292
MAY 2016
eng

Advertisement

Table of Contents
loading

Table of Contents