Oil Removal With Drain Pump; Changing The Oil Filter - Mercury 8.2 MAG Operation & Maintenance Manual

Section 4 - Maintenance

Oil Removal with Drain Pump

1. Loosen the oil filter to vent the system.
2. Remove the dipstick.
3. Install the oil drain pump onto the dipstick tube.
a
4. Insert the hose end of the crankcase oil pump onto an appropriate container and use the handle to pump until the
crankcase is empty.
5. Remove the pump.
6. Install the dipstick.

Changing the Oil Filter

NOTE: Keep oil off the exhaust manifold and also the serpentine belt.
1. Remove and discard the oil filter. If any oil escapes from the oil filter, it will exit the oil drain slot. Place a container below
the oil drain slot to catch any oil.
2. Coat the sealing ring on the new filter with engine oil.
3. Install and tighten the oil filter securely following the filter manufacturer's instructions. Do not overtighten.
4. Remove the oil fill cap.
5. Use the dipstick to determine the amount of engine oil required. Replace the dipstick.
6. Add the required amount of the recommended oil to bring the level up to the bottom of the OK range on the dipstick.
7. With the boat at rest in the water, repeat steps 5 and 6 if necessary.
NOTE: Adding 0.95 L (1 US qt) of engine oil raises the level from the bottom of the operating range to the top of the
operating range.
All Models
Engine oil (with filter)
8. Start the engine and operate for three minutes, checking for leaks.
Page 50
b
50335
a
Capacity
6.5 L (7 US qt)
a - Oil drain hose
b - Oil drain pump
a - Oil fill cap
b - Oil filter
c - Oil drain slot
b
c
50318
Fluid Type
Mercury 25W‑40 Synthetic Blend 4‑Stroke Engine Oil
90-8M0113924 DECEMBER 2015
eng