Maintenance - LNS QUICK LOAD SERVO III MI Instruction Manual

CHAPTER 8: MALFUNCTIONS / MAINTENANCE
3.

MAINTENANCE

Please read the safety instructions provided at the beginning of this manual before
handling the following devices.
3.1. Pneumatics
The air-filtering device is equipped with an automatic drainage valve, making it unnecessary to empty it.
The water recuperated comes from the pneumatic circuit of the building. It is advisable to make certain
that the air received by the bar feed system is as dry as possible (see CHAPTER 5: PNEUMATICS).
3.2. Batteries
In the event of a power failure, a backup battery saves the data contained in the SERVO amplifier. It is
possible that with time this battery will slowly drain; in this case a message will be displayed on the
remote control. The battery must be replaced as soon as possible with a battery of the same type.
Switching power off when the message "Battery low" could lead to loss of parameters.
Don't switch the power until the battery has been replaced.
3.3. Belt
It is possible that after a certain period of use the transmission belt will need to be tightened. Please refer
to CHAPTER 6: GENERAL DESCRIPTION, section 6. Belt.
3.4. Cleaning
As with any vehicle, machinery, or device, regular cleaning of your bar feed system can only serve to
improve its operation and prolong its useful life.
For cleaning on the outside, use a soft cloth and a regular detergent, for the inside, use a cloth or a brush.
However, make sure that the rollers and parts made of synthetic materials do not come into contact with
these products.
The use of compressed air for cleaning is not advisable, because particles could become lodged in
sensitive areas and impede the proper operation of the bar feed system.
At no time should solvents, such as acetone, or diluents be used for cleaning the bar feed
system. At no time should cleaning products come into contact with electrical components.
3.5. Spare parts
Without the written consent of LNS SA, no addition or modification of the machine or spare parts
can be undertaken.
LNS SA assumes no responsibility when using spare parts which were not provided by LNS SA.
QUICK LOAD SERVO III MI
8-13