Automatic Cycle - LNS QUICK LOAD SERVO III MI Instruction Manual

CHAPTER 7: OPERATION
5.

AUTOMATIC CYCLE

The barfeed autonomy is depending on the bar stocks placed by the operator on the loading ramp. This
task can be performed at anytime in the production cycle.
Every time the automatic cycle is to be started, it is recommended to check following points:
•
The pusher must be adapted to the bar stock diameter and to the spindle inner diameter (including
spindle liner).
•
The pushing force must be adapted to the bar stock material.
•
On the lathe, the clamping device must be adapted to the bar stock diameter.
QUICK LOAD SERVO III MI
7-31