LNS QUICK LOAD SERVO III MI Instruction Manual page 95

CHAPTER 7: OPERATION 7-19
Part feed out by the sub-spindle
In the case the part feed out is executed by the sub-spindle, this parameter allows to count the clamping
device openings, so that the bar feeder is still able to give an End Of Bar signal even if it does not follow
the bar stock physically.
One Shot shaft loading
This parameter enables the One Shot shaft loading, where the shaft is directly brought into top-cut
position by the loading pusher. Please contact your LNS agent for further information on this application.
QUICK LOAD SERVO III MI