Aas Ii On Valuecut - MUTOH ValueCut Series User Manual

Range: 0mm~50mm
Optimized Setting: 5mm
The cutter can not detect the marks while:
Cutter carriage is not located near the outside area of first mark before detecting
(See the picture in page 5-7 for auto-detecting area of first mark.)
Medium thickness is more than 0.8mm
Transparent medium is used
Non-monochrome drawing. The marks can't be read if is printed on colored medium
Dirty or creased medium surface

5.2.3 AAS II on ValueCut

There are three types of AAS II mark patterns: 4-Point Positioning, Segmental Positioning, and
Multiple Copies. Note that before print out your designs by inkjet printers, the registration marks
have to be created on your graphic designs by cutting software like CorelDraw plug-in.
Hand-made marks or drawings won't be reorganized by Mutoh cutting plotters. For more details
about registration mark setting in cutting software, please refer to 'Appendix A-4: CorelDraw
Plug-In Instruction".
4-Point Positioning
1.
This is the basic mark pattern that AAS II will auto detect four registration marks and contour
cut images inside those marks.
Command: Esc.D1;(XDist);(YDist):
Layout: 4 L-shaped marks at the 4 corners around the design
Segmental Positioning
2.
In addition to 4 original points, the intermediate registration marks are added on both X axis
and Y axis to help contour cut accurately, especially for cutting large images.
Command: Esc.D2;(XDist);(YDist);(XStep);(YStep):
Layout:
In-between distance on X: 200~600mm, default 300mm
In-between distance on Y: 200-600mm, default 300mm
Accu-Aligning System 5-3
ValueCut User Manual