Aas Ii On Valuecut - MUTOH VC-600 User Manual

Automatic Aligning System

Margin: The distance between marks and images
 Range: 0mm~50mm
 Optimized Setting: 5mm
The cutter can not detect the marks while:

Cutter carriage is not located near the outside area of first mark before detecting (See the
picture in page 5-7 for auto-detecting area of first mark.)

Medium thickness is more than 0.8mm

Transparent medium is used

Non-monochrome drawing. The marks can't be read if is printed on colored medium

Dirty or creased medium surface

5.2.3 AAS II on ValueCut

There are three types of AAS II mark patterns: 4-Point Positioning, Segmental Positioning, and Multiple
Copies. Note that before print out your designs by inkjet printers, the registration marks have to be
created on your graphic designs by cutting software. Hand-made marks or drawings won't be
reorganized by Mutoh cutting plotters.
1. 4-Point Positioning
This is the basic mark pattern that AAS II will auto detect four registration marks and contour cut
images inside those marks.

Command: Esc.D1;(XDist);(YDist):

Layout: 4 L-shaped marks at the 4 corners around the design
2. Segmental Positioning
In addition to 4 original points, the intermediate registration marks are added on both X axis and Y
axis to help contour cut accurately, especially for cutting large images.

Command: Esc.D2;(XDist);(YDist);(XStep);(YStep):

Layout:
In-between distance on X: 200~600mm, default 300mm
In-between distance on Y: 200-600mm, default 300mm
54
ValueCut USER MANUAL
V5a 2015 Jan