Changing Detector Sensitivity - Honeywell Notifier NFS2-640/E Programming Manual

Status Change
To
Save the status
Go to the next or previous
point address

3.4 Changing Detector Sensitivity

To select a detector, enter the SLC address (2D101) of an installed detector in the "LDAAA" field
(shown above). The control panel displays the following screen:
Use the instructions below to set/change detector sensitivity, display additional detectors, and set
Pre-alarm values.
NOTE:
"Pre-Alarm" on page 99.
To
Display detector information on
the screen.
Set alarm sensitivity level.
Set Pre-alarm level
Save the sensitivity values.
Display the next existing
detector address.
Display the previous existing
detector address.
54
Table 3.1 Changing the Status Banner (2 of 2)
Press
The Detector Sensitivity option lets you change the Alarm and Pre-Alarm
(sensitivity) level for an installed detector. From the "Status Change Selection"
screen, press the 2 key to display the "Detector Selection" screen as shown
Status C
below:
Passwo
D E T . S E N S . & C O M P .
P R O G R M S M O K E ( P H O T O ) D E T E C T O R A D D R 2 D 1 0 1
If not using Pre-Alarm, set PA=0. PA=1 is the self-optimizing mode. For details, refer to
(Next Selection) or (Previous Selection)
E N T E R P O I N T S : L D A A A , E
0 3 _ _ _ _ _ _ _ _ A 8 P 8 A V 2 D 1 0 1
Alarm Level
Enter or Press
The detector address, then press
A value (1-9) or increase or decrease values by pressing
the or keys:
NEXT PREVIOUS
A value (0-9) or increase or decrease values by pressing
the or keys:
NEXT PREVIOUS
(Next Selection)
(Previous Selection)
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
Changing Detector Sensitivity
Pre-Alarm Level
.
or .
or .