C.5.4: Print A Detector Maintenance Report; C.5.5: Interpreting A Detector Status Display Or Maintenance Report - Honeywell Notifier NFS2-640/E Programming Manual

Intelligent Sensing Applications
C.5.4 Print a Detector Maintenance Report
A Detector Maintenance Report lists detector maintenance status for each installed addressable
detector [except FDX-551(an analog heat detector)].
When you press and enter the P key the control panel sends a Detector Maintenance Report (Figure
C.8) to the printer connected to the control panel.
Detector Maintenance Report
1
*** PRINT SMOKE DETECTOR MAINTENANCE
NORMAL SMOKE (PHOTO) INTENSIVE CARE UNIT Comp:032%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D044 Comp:027%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D045 Comp:028%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D046 Comp:030%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D047 Comp:024%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D048 Comp:031%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D049 Comp:033%
NORMAL SMOKE (PHOTO) DETECTOR ADDR 1D050 Comp:008%
****************************
***************************************
C.5.5 Interpreting a Detector Status Display or Maintenance Report
Detector Maintenance Status Screens and Detector Maintenance Reports provide the same
information (such as Device Status, Compensation, Peak Value) about a detector. This section
contains descriptions of each item that appears in a Detector Maintenance Status Screen or a
Detector Maintenance Report.
NORMAL SMOKE (PHOTO)
1 2
1. Device Status (NORMAL) The status of the detector: NORMAL, ALARM, DISABL OR
TEST.
2. Type Code (SMOKE (PHOTO)) The software Type Code that identifies the type of detector.
Refer to "Intelligent Detector Type Codes" on page 112.
3. Custom Label (DETECTOR ADDR 1D044) The 19-character user-defined custom label.
4. Drift Compensation (COMP:027%) The relative cleanliness of a detector determined by
sampling the amount of contaminants in the detector, ambient air conditions, and the age of the
detector. The Comp value also indicates if a detector requires maintenance. Refer to
"Maintenance Warnings – Three Levels" on page 96 for definitions of maintenance levels. The
table below contains a list of the maintenance level values for each type of detector:
Type of Detector
Ion
Photo
Laser
Acclimate Plus™
5. Peak Value (PK:0001%) The highest analog value reached by the detector during the past
week. The peak value slowly returns to zero.
104
***
PRINT END
Figure C.8 Sample Detector Maintenance Report
DETECTOR ADDR 1D044 Comp:027%
3
Table C.3 Maintenance Levels by Detector Type
Low Chamber
Normal
Reading
006-068 less than 006
006-069 less than 006
003-063 less than 003
n/a LO-VAL
Pk:0002% 000% A8 8 **
Pk:0001% 000% A8 8 **
Pk:0001% 000% A8 8 **
Pk:0001% 000% A8 8 **
Pk:0002% 000% A8 8 **
Pk:0002% 000% A8 8 **
Pk:0002% 000% A8 8 **
Pk:0003% 000% A8 8 **
Pk:0001% 000%
4 5 6
Maint. Alert
92-99
93-99
83-99
Dirty1
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
Detector Maintenance Features
1D043
1D044
1D045
1D046
1D047
1D048
1D049
1D050
A8 8 C * 1D044
7 8 9 10 11
Maint. Urgent
100
100
100
Dirty2