Honeywell Notifier NFS2-640/E Programming Manual page 78

Releasing Applications
SECOND SHOT
NOTE: The Second Shot switch can only be used with the
The following contains information needed to program a Second Shot switch for a monitor module
Description

A monitor module—connected to a UL-listed manual station (such as the NBG-12LRA)—used as
for a second release of agents. A Second Shot switch overrides a Delay Timer, programmed to the
same Releasing Zone.
Programming

1. Select a monitor module (refer to "Modify or Delete a Point (2=point)" on page 19) to use for
the manual release function.
2. Select the
3. Select the Releasing Zone (R0-R9) for your releasing application.
4. Press the
screen.
Examples

A programming example of a monitor module programmed as a Manual Release Delay switch
(Type Code
for the second shot.
With two monitor modules configured as shown above, program Releasing Zone R5 with the
following releasing selections.
R05 can be activated in one of two ways, as described in the examples given below.
78
Type Code
Type Code.
SECOND SHOT
P R O G R M S E C O N D _ S H O T
key to save, then press the
ENTER
) for the first shot and a Second Shot switch (Type Code
MANREL DELAY
NBG-12LRA station with
SYSTEM SYSTEM
NORMAL ACTIVATED
Manual Release lever
Monitor
Module
2M101
Type Code
MANREL DELAY
Figure A.13 Monitor Module Configured as a Second Shot Switch
P R G R E L E A S E F U N C T I O N R E L E A S E C O N T R O L
D E L A Y = 1 5 A B O R T = U L I C R O S S = Y S O K = 0 0 3 0 R O 5
MANREL DELA
Type Code selection:
SECOND
M O D U L E A D D R 2 M 1 0 1
R 5 _ _ _ _ _ _ _ _
Releasing Zone selection (R5 shown)
key until you return to the Program Change
ESC
Monitor
Module
Detector
2M102
R05
Control
B01
Module
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
How to Program a Releasing Zone
y Type Code.
_
SHOT
2 M 1 0 1
SECOND SHOT
Second
Shot
Switch
Type Code
SECOND SHOT
)