Disable Or Enable A Point - Honeywell Notifier NFS2-640/E Programming Manual

Disable or Enable a Point

3.3 Disable or Enable a Point
WARNING:
!
Do not rely on disable/enable software settings to lock out releasing devices. Releasing devices
must be physically disconnected.
NOTE: When an input or output point associated with releasing functions is disabled, a single
supervisory trouble will be generated.
Status Change
Password
1. From the "Status Change Selection" screen, press the 1 key to display the "Disable/Enable"
screen.
2. Select the point type:
The cursor will blink the first SLC address digit in the detector, zone, module, or NAC field.
D
WARNING:
!
Disabling a zone disables all input and output devices that use the zone as the first entry in the
CBE list.
3. Enter the address of the point, then press the
When you disable a point and press the
panel: a) turns on the
banner to
You can disable or enable a point by changing the status banner as follows:
To
Change the status
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
The Disable/Enable option lets you disable programmed points for detectors,
modules, zones, and NACs. The program allows you to disable an initiating
device in alarm: however, the disable will not take effect until after the panel
has been reset.
for detectors
for modules
for NACs
for zones
Blinking status banner (ENABLE or DISABL)
E N A B L E C O N T R O L
POINT DISABLED
for the point.
TROUBL
Table 3.1 Changing the Status Banner (1 of 2)
Press
Maneuver the cursor with the arrow keys until it is in the status field. Press
(Next Selection) or
key. A sample display follows:
ENTER
C O N T R O L A D D R E S S 2 M 1 0 1
0 0 _ _ _ _ _ _ _ _ I S W
key to return to the Disable/Enable screen, the control
ESC
LED; b) sounds the panel sounder; and c) changes the status
(Previous Selection)
Status Change
2 M 1 0 1
53