5: Create A System Message (4= Message ) - Honeywell Notifier NFS2-640/E Programming Manual

Programming
A Forgotten Password?
If a password is entered incorrectly, the panel will respond by displaying an
message and a code. The programmer may hit escape and reenter the password correctly. However,
if the password has been forgotten, record the code and contact Notifier. After proper
authentication, the original password can be determined by deciphering the code. An example of an
INCORRECT PASSWORD
2.3.5 Create a System Message (4=
Program Change
Password
From the "Basic Program" screen, press the 4 key to display the "System Message Change" screen:
To create the system message, follow these guidelines:
• Enter one character at a time, indicated by the blinking cursor on the second line of the
display.
• Enter up to 40 characters maximum.
Instructions for entering characters in the Message Change screen:
To
Change a blinking character
Move to the next character
Enter lower case characters
Enter additional characters !
@ = , % : \ . I ?
Save the new message
26
display is given below:
I N C O R R E C T P A S S W O R D
P R O G R A M : 9 0 6 6 - 2 1 F 5 - 7 D 7 8 - 5 F A 4 - 6 1 6 3
Code
The Message option lets you create a 40-character custom System Message
that displays on the first line of the "
below:
Y O U R C U S T O M M E S S A G E H E R E
S Y S T E M N O R M A L
S Y S T E M N O R M A L
Blinking cursor prompt
Table 2.8 Creating Messages
Do this
Enter a character from the keypad
Press
Press
Press
For example, press
a "=" character.
Press
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
)
MESSAGE
SYSTEM NORMAL
0 2 : 2 4 P 0 4 1 5 0 8 T u e
Message change area
, then press the character of your choice.
, then press a number key as follows:
3 (
, then press the
Basic Program
INCORRECT PASSWORD
' screen as shown
) key to enter