Honeywell Notifier NFS2-640/E Programming Manual page 40

Programming
ACS Selection Group L (SLC #1, Detectors 129-159, and SLC #2, Detectors
129-159):
Point
1
2
3
to
31
32
33
34
35
63
64
* Pressing the switch button when the Switch Function is "Not Used" will cause the associated LED to stop
blinking. This is a local acknowledgement at the annunciator only: no message is sent to the panel.
NOTE:
1. Point number to Detector number relationship is sequential. To determine Point to Detector
relationship add 128 to Point number to arrive at Detector number.
2. Point number to Detector number relationship is sequential. To determine Point to Detector
relationship add 96 to Point number to arrive at Detector number.
ACS Selection Group M
FirstCommand NFC-50/100 and FireVoice (NFV-25/50ZS) are single channel and can play one
message. Message priority is determined by the message number: lower-numbered messages have
the higher priorities (that is, Message 2 has a higher priority than Message 3). Message 0 (OFF) has
the lowest priority.
To use ACS for controlling the FirstCommand and FireVoice, install by programming Annunciator
A1 as Group M through panel or VeriFire Tools programming. Refer to the First Command or
FireVoice manual to properly configure the FACP.
VeriFire Tools Programming

Annunciator programming must be performed as follows:
• Program Annunciator Address 1 as Group M. (Refer to Table 2.26 for point definitions.)
• Assign ACS points in user Map 1.
40
Table 2.25 ACS Group L
Type Red LED
Input SLC 1, Detector 129 Alarm SLC 1, Detector 129
Input SLC 1, Detector 130 Alarm SLC 1, Detector 130
Input SLC 1, Detector 131 Alarm SLC 1, Detector 131
to (see note 1)
Input SLC 1, Detector 159 Alarm SLC 1, Detector 159
Not Used
Input SLC 2, Detector 129 Alarm SLC 2, Detector 129
Input SLC 2, Detector 130 Alarm SLC 2, Detector 130
Input SLC 2, Detector 131 Alarm SLC 2, Detector 131
to (see note 2)
Input SLC 2, Detector 159 Alarm SLC 2, Detector 159
Not Used
Yellow LED
Trouble
Trouble
Trouble
to (see note 1)
Trouble
Trouble
Trouble
Trouble
to (see note 2)
Trouble
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
Basic Program
Switch Function*
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used