Honeywell Notifier NFS2-640/E Programming Manual page 12

General Information
From the "SYSTEM NORMAL" screen: Press
Enter a password, then press
In Program Change or Status Change, the control panel does the following:
• Activates the System Trouble relay
• Shuts off the panel sounder
• Flashes the
For security purposes, passwords can be changed. To do so, follow the instructions in "Change a
Password (3=passwd)" on page 25.
NOTE: The Read Status selection, which does not require a program password, is covered in
NF2S-640
the
NOTE: The
autoprogramming.
12
ENTER
ENTER PROG OR STAT PASSWORD, THEN ENTER.
(ESCAPE TO ABORT) _
Figure 1.1 Password Screen
LED, which continues to flash while programming
SYSTEM TROUBLE
Operations Manual.
NF2S-640
continues to monitor and report alarms in programming mode, except in
, press 1 (the password screen will display).
ENTER
Enter password here (00000 or 11111)
NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
How to Enter a Password