Komatsu PC118MR-8 Operation And Maintenance Manual page 396

EQUIPMENT USE GUIDE
These tables list the combination of attachments which can be installed on boom and 2-piece boom machines with
different arm lengths.
NOTICE
q When machine is 2-piece boom, if the bucket is drawn to the machine operators cab, the arm
interferes with the machine operators cab.
While digging in an oblique direction, and when the 2-piece boom is fully down, it interferes with the
undercarriage. Operate the boom with care.
1. Bucket size based on ISO 7451, heaped material with a 1:1 angle of repose.
2. Max Bucket Volume/Weight are for reference only and are not necessarily available from the factory.
3. Table is based on General Purpose buckets and both conditions of Volume (m
exceeded.
4. Please consult with your distributor for the correct selection of buckets and attachments to suit the application.
The recommendations are given as a guide only, based on typical conditions.
q To dig and load hard or rocky earth, it is advisable to use a long-life reinforced bucket, highly wear-resistant.
Characteristics of the equipment (managed exclusively by Komatsu or its authorised distributor)
Picture
Description
reference
1 Core machine
Boom
Two-piece boom
Arm 1850 mm
Arm 2000 mm
Work
2
Long boom
Equipment
2300 mm
Mechanical quick
coupling device
Hydraulic quick
coupling
4 Additional counterweight
6-6
Working
Weigth
pressure
Category
kg Mpa
– 10581
Equipments 696
Equipments 1043.5
Equipments 323
Equipments 358
Equipments 378
Interchangeable
89
equipment
Interchangeable
95
equipment
– 388
WEAM014802
OPTIONAL EQUIPMENT
3
) and Weight (kg) must not be
Main dimension
Working
flow
Height
l/min mm
– – –
– – –
– – –
– – –
– – –
– – –
– – –
30 – –
– – –
ISO Lifting
capacity capacity
Width
3
mm m kg
– – –
– – –
– – –
– – –
– – –
– – –
– – –
– – –
– – –