Komatsu PC118MR-8 Operation And Maintenance Manual page 263

FUNCTIONING
6. Stop the machine where requested, then slowly rotate the
turret of 180°.
Securing the machine on the means of transport
After positioning the machine on the trailer, it is necessary to secure it by proceeding as indicated below.
NOTICE
q Keep the aerial and the other components. Make the
mirrors (for machines fitted with them) folded up into
the machine profile.
q To avoid damaging the bucket cylinder during
transport, position a wooden block at one end of the
cylinder to prevent it from touching the ground.
1. Lower the blade.
2. Fully extend the bucket cylinder of the 2nd boom and lower
the 1st boom slowly.
3. Place the safety locking lever (1) in the LOCK position (L).
4. Stop the engine, then remove the key from the starting
switch.
5. Lock the cab door and cases with lock, see section
"HOODS AND DOORS FITTED WITH A LOCK (3-83)".
6. Place blocks under both ends of the tracks to prevent the
machine from moving during transport and secure the
machine with sufficiently strong chains or metal cables.
Pay special attention when securing the machine, to
prevent it from sliding laterally.
When the machine is fastened with a chain or a metal rope,
use the bore in the lower car back and the bore in the blade
side plate.
WEAM014802
TRANSPORTATION
3-179