Komatsu PC118MR-8 Operation And Maintenance Manual page 208

USE OF THE MACHINE AND RELATED CONTROLS
Rear view mirrors
q Always check the cleaning and correct orientation of the rear-view mirrors before starting to work;
they must allow to control the rear area control without moving the log in relation to the normal
working position.
If working with no control at the back of the machine, incautious people who may have entered into
the working zone may be run down, or fixed obstacles or motor vehicles may be crashed during
operation.
q If rear-view mirrors shall be moved or broken during work, stop the engine immediately and fix or
replace them.
Mirror (A)
Adjust the mirror support in a way that will enable you to see
the people in the rear left hand side of the machine.
q Install the lateral mirror in the position indicated in the
figure on the right.
(E): approx 100 mm
q Fix the mirror safety support (1) perpendicular to the cab.
q When adjusting the side mirror angle, loosen the mirror
fastening screws (2) to ease the movement if necessary.
Screw (2) tightening torque: 15.7–19.6 Nm
3-124
WARNING
WEAM014802
FUNCTIONING