Komatsu PC118MR-8 Operation And Maintenance Manual page 267

FUNCTIONING
6. Pass the metal cables between the first and the second
carrier roller starting from the front, and between the first
and the second carrier roller starting from the back.
7. Place the wooden blocks between the cables of metal and
the machine to avoid them both getting damaged.
NOTICE
Do not attempt to lift the machine by attaching a metal
cable to the bracket supplied to secure the machine during
transport, since this procedure may damage the machine.
8. Configure the angle between the cables of metal (A); it
must be between 30° and 40°, only then lift the machine
slowly.
9. When the machine is not in contact with the ground any
longer, check the conditions of the hook and the lifting
position, then lift slowly.
WEAM014802
TRANSPORTATION
3-183