Table of Contents
Advertisement
OC3port Plus
Users Manual
Connecting the OC3port Plus to a Modem
When you use a modem, you must set the baud rate on the OC3port Plus and on
the receiving device. Follow these steps to set up the OC3port Plus for modem
communications:
1. Set up the OC3port Plus as described under "Connecting to the Network" in
this chapter.
2. Use the RS-232 line to connect the OC3port Plus to the modem.
3. Make the necessary hardware and software connections on the receiving end.
4. Turn on the OC3port Plus. Wait until the self-test ends (when the tester
"beeps").
5. Press the
6. Press the
line. Then, press the
(96 = 9600 baud; 24 = 2400 baud; or 12 = 1200 baud).
7. When the port speed you want is displayed, press
The OC3port Plus is now connected to the modem. After the remote session
starts, the OC3port Plus simultaneously sends all test results.
Connecting to a Printer
To connect the OC3port Plus to a printer, do the following:
1. Connect the OC3port Plus to the serial port on the printer.
2. Power on the printer.
3. Power on the OC3port Plus.
2-20
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
key. The
OPTIONS
OPTION SELECTIONS
OPTION
SELECTIONS
- - - - - - - - - - - - - - - - - - - - - - -
Parameter Set
RS-232 Speed
key until the RS-232 Speed option is on the selection
Down Arrow
or
Left
Right Arrow
menu is displayed:
1
96
key to display the desired port speed
.
ENTER
za008f.eps
Advertisement
Table of Contents
