Running A Remote Cell Loss Test - Fluke OC3port Plus User Manual

OC3port Plus
User Manual

Running a Remote Cell Loss Test

To run a Remote Cell Loss test, connect the two testers across the ATM network
ports under test. Then, complete the following steps first on the slave unit, then on
the master unit.
1. Press the
2. Press the
line. Then, press
3. Make sure that the
. The
ENTER
4. Make sure that the
of the following:
a. If the tester you are programming is the slave unit, press the
Arrow
and complete this entire procedure again on the master unit.
b. If the tester you are programming is the master unit, press the
Arrow
The Remote Cell Loss test begins. The master and slave units synchronize
with each other. Then, results are provided to you on the master unit's
LCD. See "Understanding Cell Loss Test Results", which follows, for a
detailed description of the test results.
6-64
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
key. The
ATM ATM SELECTIONS
key to move the
Down Arrow
. The
ENTER QUALITY OF SERVICE
QUALITY OF SERVICE
- - - - - - - - - - - - - - - - - - - - - - - -
Cell Loss
1Pt Cel Dly Var
option is on the selection line. Then, press
Cell Loss
submenu is displayed:
CELL LOSS
CELL LOSS:
- - - - - - - - - - - - - - - - - - - - - - - -
Start Cell Loss STD
Setup Cell Loss
option is on the selection line. Then, do one
Start Cell Loss
key to change the setting to SLV. Press
key to change the setting to MAS. Press
menu is displayed.
option to the selection
Quality of Service
submenu is displayed:
1
Left or Right
. Then, go to Step 1
ENTER
.
ENTER
za134f.eps
za135f.eps
or
Left Right