Table of Contents
Advertisement
Receiving an IP Message
There may be situations in which you want to test connectivity to a network by
setting up the OC3port Plus as the destination device and then determining
whether it can receive an IP message from a network client. This procedure shows
you how to do this.
1. Set up RECEIVE FILTER 1 with the desired VPI / VCI.
The OC3port Plus uses the VPI/VCI specified on RECEIVE FILTER
1 to receive IP Ping messages and to respond to those messages.
2. Press the
AUTO
3. Make sure that the
The
submenu is displayed.
IP PING
4. Press the
Down Arrow
line.
This option identifies which address in the IP address table corresponds to the
OC3port Plus. The settings for this option range from 1 to 8, which
respectively correspond to the eight addresses listed in the IP ADDRESS
TABLE.
5. Press the
Left
in the IP ADDRESS TABLE corresponding to the OC3port Plus.
6. Press the
Down Arrow
selection line, as in the following:
IP PING
IP Ping Test
IP Ping Responder
Source IP Addr
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Note
key. The
AUTO SELECTIONS
option is on the selection line. Then, press
IP Ping
key to move the
Source IP Addr
or
key to select the setting that matches the address
Right Arrow
key to move the IP Ping Responder option to the
Testing ATM Networks
IP Ping Test
menu is displayed.
ENTER
option to the selection
1
1
6
.
za171f.eps
6-87
Advertisement
Table of Contents
