Table of Contents
Advertisement
Laser Operation
The single-mode version of the OC3port Plus contains a laser transmitting device.
As a safety precaution, this transmitter is off when the tester is powered on. For
the tester to function, you must turn on the laser setting. See "Starting the OC3port
Plus" in Chapter 3 for instructions on how to turn on the laser transmitter. The
laser turns on automatically if there is an input signal while you are running the
automatic diagnostic tests.
Checking Your Package
Take time to check your OC3port Plus package. The following items are included:
•
3'TSVX 4PYW 2IX[SVO %REP]^IV 9WIVW 1ERYEP
•
%' EHETXIV GLEVKIV
•
3'TSVX 4PYW RIX[SVO EREP]^IV
•
6. XS 6. GEFPI
•
6. XS (& JIQEPI EHETXIV
•
(& XS (& JIQEPI EHETXIV
•
DB-9 to DB-25 male adapter
If your package does not contain an item from this list contact Fluke at one of the
telephone numbers listed under "Technical Support" below.
Technical Support
Fluke Corporation offers a variety of support options to help you get the most from
your OC3port Plus. If you require technical support, please have the following
information available:
•
Your name and company.
•
OC3port Plus model number and serial number.
•
OC3port Plus software revision that appears when you power on the unit.
•
Any error messages or flags that appear on the screen.
•
Make, model numbers, and configurations of equipment under test.
•
A printout of the setup parameters for the OC3port Plus.
For application or operation assistance or information about the OC3port Plus,
call:
USA and Canada: 1-888-993-5853
Europe: +31 402-678-200
Japan: +81-3-3434-0181
Singapore: +65-738-5655
Anywhere in the world: +1-425-356-5500
Or, visit Fluke's web site at
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
.
www.fluke.com
Introduction
1
Laser Operation
1-11
Advertisement
Table of Contents
