Table of Contents
Advertisement
Setting Up the Slave Unit
On the slave unit, you need to do the following:
1. Identify the address on which to receive the trigger burst transmission from the
master unit.
2. Specify the number of cells to expect in the trigger.
3. Identify the address of the cell transmission.
4. Specify the length of time to wait for cells from the slave unit and the length of
time to transmit cells.
Step 1: Identify the address of the trigger burst transmission and number of cells
to expect in the trigger.
1. Press the
ATM
2. Press the
Down Arrow
line. Then, press
3. Press the
Left
:
2
RECEIVE FILTER:
NAME:FILTER_2_
LOAD TX HDR TX1
4. Press the
Down Arrow
press the
EDIT
set up TRANSMIT STREAM 2 on the master unit. Make sure that you press
to save the change.
ENTER
Program the entire header for RECEIVE FILTER 2 in this manner, making
sure that the value you specify for each option matches its counterpart on
TRANSMIT STREAM 2 on the master unit.
The slave unit is now configured with the address of the trigger burst
transmission.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
key. The
ATM SELECTIONS
key to move the
Setup RX Filtrs
. The submenu
ENTER
or
key to display the submenu for
Right Arrow
or
for Change
key to move the
VPI
key and change the
to the same value you used when you
VPI
Testing ATM Networks
Quality of Service Tests
menu is displayed.
option to the selection
is displayed.
RECEIVE FILTER 1
RECEIVE FILTER
2
option to the selection line. Then,
6
za146f.eps
6-59
Advertisement
Table of Contents
