Table of Contents
Advertisement
TM
OptiView
Getting Started Guide
Setting the Remote Control PC IP Address
Set this field to specify an offnet PC running the OptiView Browser
interface software. By setting this field, the analyzer will send its identification
back to the specified PC running the remote user interface software. Set this field
to <none>, <last connected>, or manually enter the IP address of the remote PC
that will be running the OptiView
connected> is the last remote session to terminate from the analyzer, and that PC's
IP address is saved into this field.
This address is configured in the Setup | Security screen. Optionally, this address
can be configured through the RS-232 configuration port. This is done so that
analyzers that are placed on network segments other than the one the controlling
PC is on will still automatically show up in the OptiView Browser
available analyzers.
Setting the OptiView Inspector Console Address
The Fluke Networks OptiView Inspector Console
Network Inspector
software tool for network engineers, LAN administrators, and network technicians
who maintain LANs (Local Area Networks). The application allows you to
monitor, map, and troubleshoot a LAN segment that could consist of servers,
routers, switches, printers, managed hubs, and clients (hosts and other network
devices).
The OptiView Inspector Console
the analyzer and the OptiView Inspector Console
should be the IP address of the machine running the OptiView Inspector Console
program. The analyzer will send packets to this address when it is connected to the
network, or when the IP address of the analyzer changes.
These packets assist the OptiView Inspector Console
information current. OptiView Inspector Console
Fluke Networks' products that are connected to the network and can even be used
to launch a user interface session on any OptiView
OptiView
Console
TM
OptiView Inspector Console
can be downloaded from www.flukenetworks.com.
Setting the Analyzer IP Address on the Network Under Test Interface
The Network Under Test Interface represents the 10/100-BASE-T, 100BASE-FX,
and 1000BASE-X ports. It does not include the Management port. To set the IP
address of the Network Under Test Interface, select Setup | TCP/IP. Refer to the
analyzer Help on configuring this screen.
24
) is a Windows 2000
TM
analyzer can be used as an agent for the OptiView Inspector
TM
.
is purchased separately. A 7 day evaluation copy
TM
TM
Browser remote user interface software. <last
application (formerly called
TM
, Windows 98
TM
field is used to enhance the interoperability of
TM
product. The address you enter
TM
TM
maintains a special list of all
TM
Workgroup Analyzer. An
TM
remote user
TM
list of
TM
, and Windows NT
TM
product in keeping its
TM
TM
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiView Series and is the answer not in the manual?