Festo CPA VI Series Manual page 99

5. Maintenance and conversion
1
Sub-base to be
replaced
Fig. 5/7: Removing sub-bases
1 Unlocking the
manifold block
2 Removing the
manifold block
from the sub-
base
Fig. 5/8: Removing the manifold block
Festo P.BE-CPA-EN en 0207c
9. Replacing a sub-base or a manifold block:
Use the appropriate sub-bases of the tie rod (see
Fig. 5/7). Release and carefully remove the manifold block
from the sub-base (see Fig. 5/8). Remove the seals from
the sub-base or manifold block to be replaced.
1
1
2
5-15