5. Maintenance and conversion
Festo P.BE-CPA-EN en 0207c
Fitting
1. If you wish to add valve locations, mount the appropriate
manifold block (EV1 or EV2) on the sub-base. Finally, fit all
the valve locations and the end plate (see this chapter,
"Replacing an end plate, sub-base or manifold block").
2. Fit the appropriate components in the empty valve loca-
tions (see this chapter, "Replacing sub-bases, blanking
plates or additional supply plates ").
3. Fit the CPA valve terminal onto its fastening surface (see
chapter 2 "Fitting onto a wall" or "Fitting onto a hat rail").
5-31