Festo CPA VI Series Manual page 94

5. Maintenance and conversion
1 CPA valve
terminal with MP,
CP, AS-Interface
connection or
CPX terminal
2
CPA valve
terminal with
IC connection
Fig. 5/2: Removing the valve sub-bases
5-10
Loosening the components
1. Loosen the fastening screws of the relevant components
(position of the fastening screws see diagram). Use a slim
screwdriver to do this.
2. Remove the component from the sub-base of the CPA
valve terminal.
1
Fitting the components
1. Make sure the seal is not damaged.
2. Replace the seal if it is damaged.
3. Make sure that the seal is seated correctly. It must lie in
the recess in the sub-base.
2
Festo P.BE-CPA-EN en 0207c