Festo CPA VI Series Manual page 26

1. System summary
Ident. code Pneumatic components
B Valve sub-base, 5/3-way, mid position pressurized
D Additional supply plate, for compressed air supply of three and more pressure
zones
I Valve sub-base, 5/3-way, mid position exhausted
G Valve sub-base, 5/3-way, mid position blocked
H Valve sub-base, two 3/2-way, control side 12 in basic position open, control
side 14 in basic position closed
J Valve sub-base, 5/2-way, double-solenoid
K Valve sub-base, two 3/2-way, single-solenoid, in basic position blocked
M Valve sub-base, 5/2-way, single-solenoid
N Valve sub-base, two 3/2-way, single-solenoid, in basic position open
T Sub-base for pressure zone separation, compressed air channel (1) blocked
Y Valve sub-base, 5/2-way, single-solenoid on two-coil valve location
Tab. 1/2: Ident. code of the pneumatic components
1-10
By means of the identification code, you can ascertain which
valve sub-bases are fitted on your CPA valve terminal. This
code is printed on the front of the valve sub-base.
Further information on the valve sub-bases can be found in
Appendix A.
Festo P.BE-CPA-EN en 0207c