Festo CPA VI Series Manual page 114

5. Maintenance and conversion
5-30
Proceed as follows:
Removing
1. Loosen the CPA valve terminal from its fastening surface
(see this chapter, "Dismantling the CPA valve terminal").
2. Unclamp the CPA valve terminal. Loosen the fastening
screws of all components on the valve locations approx.
2 turns. Remove all the components from the valve
locations which you wish to remove (see this chapter,
"Replacing sub-bases, blanking plates or additional
supply plates").
3. Remove the appropriate end plate and pull the valve
locations from the tie rods. Remove the appropriate valve
locations (see this chapter, "Replacing an end plate, sub-
base or manifold block").
4. Adapt the tie rods to the new number of valve locations
(see tables for the tie rod components and Fig. 5/12).
Please note
When extending the CPA valve terminal with tie rod exten-
sion, make sure that the terminal is flush with the basis tie
rod.
Use the tie rod extension only for two additional valve loca-
tions. Further tie rod extensions are not permitted. In this
case use correspondingly longer basis tie rods.
Festo P.BE-CPA-EN en 0207c