Festo CPA VI Series Manual page 135

B. Supplementary component summary and installation instructions
Festo P.BE-CPA-EN en 0207c
Further information on replacing the CPA pneumatic interface
can be found in the CPX system manual.
5. Check the pneumatic adapter on the left-hand end plate
of the CPA valve terminal for damage. If necessary replace
the pneumatic adapter. Dismantling is described in the
section "Replacing the end plate, sub-base or manifold
block."
Fitting
1. Insert the electrical bridge in the contact strip of the CPX
terminal.
Fig. B/7: Fitting the electrical bridge
2. Push the CPA valve terminal together with the CPX ter-
minal. Make sure that the electrical bridge is correctly
seated in the contact strips.
B-9