Festo CPA VI Series Manual page 98

5. Maintenance and conversion
1 Fastening screws
of the electric
sub-base
2 Fastening screws
of the cover block
Fig. 5/6: Removing the sub-base or cover block
5-14
6. Depending on the component to be replaced, loosen the
tie rod screws in the left or right-hand end plates (see
diagram).
Fig. 5/5: Loosening the tie rod screws
7. Remove the appropriate end plate from the tie rods.
8. Replacing an end plate:
Loosen the four fastening screws of the electrical sub-
base or cover block and remove it from the relevant end
plate (see diagram).
1
2
Festo P.BE-CPA-EN en 0207c