Table of Contents
Advertisement
7
Installation
7.3.6
Energy chain subdivision X-modules
Chambers for EHMX-EGC-50/-80/-120/-185
1
2
3
4
5
6
1) View of open end of the energy chain
7.3.7
Installation
Note
Hoses that are permanently in contact with cables can react negatively to their material.
• Install hoses separately from the cables.
• Install cables and hoses separately from each other. If required, add additional separators.
• Do not put motor cables together with encoder cables or plug sockets with cables in one chamber.
• Install cables and hoses twist-free and without mechanical tension. Cables and hoses must be able
to move freely within the curvature radius of the energy chain.
• Attach cables and hoses to the chambers of the energy chain end pieces with cable ties.
Energy chain Z-module
1. Place customer-specific cables and hoses of the mounting parts into the corresponding chambers
of the energy chain Z.
Energy chain Y-module
1. Push the slide of the Y-module up to the end stop so that the maximum possible length of the en
ergy chain Y lies flat.
2. Place customer-specific cables and hoses from the energy chain Z into the energy chain Y.
80
1)
For customer-specific allocation
For customer-specific allocation
Plug socket with cable
Encoder cables and earthing cable
Motor cable (servo motor) or hoses for pneumatic drive
Motor cable (servo motor)
Festo – GDCP-YXC-EN – 1502NH – English
Advertisement
Table of Contents
