Festo YXC Series Description, Mechanical Installation page 34

4 Installation of the single-axis systems and the linear gantries
On the front:
2. Unscrew screws on the upper parts.
3. Position lower part.
4. Place washers underneath the screws.
5. Using suitable screws
part to the mounting surface.
6. Press bolt from below into the intended
hole in the lower part.
7. Turn screw into the adjusting piece.
8. Place washer below the nut.
9. Screw nut onto the screw.
1) The accompanying screw and tightening torque are designed for mounting on steel.
34
1)
, lightly clamp lower
Festo – GDCP-YXC-EN – 1502NH – English