Festo YXC Series Description, Mechanical Installation page 60

5 Installation of the planar surface gantries and the three-dimensional gantries
4. Push slide into the corresponding end position:
– The hollow shafts no longer turn when the clamping screws are tightened.
5. Push the drive shaft with the expanding
mandrel as far as possible into the hollow
shaft.
6. Tighten clamping screws.
Screw size and tightening
torque
[Nm]
60
EHMX-EGC-
50 80
M3 M5
1 7
120 185
M8 M10
14 60
Festo – GDCP-YXC-EN – 1502NH – English