5
Installation of the planar surface gantries and the three-dimensional gantries
8. Align X-axes exactly with each other
(è 5.3.1 Installation YXCF/YXCR).
9. Screw adjusting bolts in or out
(maximum height compensator è Table).
10.Tighten screws. Apply counter pressure to the
adjusting bolt.
Check:
The adjusting bolt has not twisted.
–
– The alignment has been maintained.
11.Make sure there is sufficient screw-in depth m
of the screw (è Table).
Screw size and tightening
1)
torque
M
A
m
h
Max. height compensator [mm]
1) Screw, tightening torque and screw-in depth are designed for mounting on steel.
50
EHMX-EGC-
50
M5x30
[Nm]
5.9
12
[mm]
[mm]
7 ± 2
4
80
120
M8x40
34
15
8 ± 3
6
Festo – GDCP-YXC-EN – 1502NH – English
185