Air Cleaner - Honda CBR650F Service Manual

dummyhead dummyhead
Throttle grip freeplay can be adjusted at either end of
the throttle cable.
Minor adjustment is made with the upper adjuster of the
throttle grip side.
Slide the boot [1] to remove it from the adjuster [2].
Loosen the lock nut [3] and turn the adjuster as
required.
Tighten the lock nut to the specified torque while
holding the adjuster.
TORQUE: 3.8 N·m (0.4 kgf·m, 2.8 lbf·ft)
Install the boot over the adjuster properly.
Major adjustment is made with the lower adjuster on the
throttle body.
Remove the air cleaner housing (page 7-12).
Loosen the lock nut [1] and turn the adjuster [2] as
required.
Tighten the lock nut to the specified torque while
holding the adjuster.
TORQUE: 5.5 N·m (0.6 kgf·m, 4.1 lbf·ft)
After adjustment, recheck the throttle operation.
Install the air cleaner housing (page 7-12).

AIR CLEANER

• The viscous paper element type air cleaner cannot
be cleaned because the element contains a dust
adhesive.
• If the motorcycle is used in unusually wet or dusty
areas, more frequent inspections are required.
Lift the fuel tank and support it (page 3-4).
Disconnect the IAT sensor 2P (Black) connector [1] and
release the wire [2] from the wire guides [3]
Remove the tapping screws [4] and air cleaner lid [5].
Remove the two tapping screws [1] and air cleaner
element [2].
Replace the air cleaner element in accordance with the
maintenance schedule (page 3-2) or any time it is
excessively dirt or damaged.
Clean the inside of the air cleaner lid and housing.
Make sure the rubber seals in the housing and lid is in
position and in good condition.
Installation is in the reverse order of removal.
TORQUE:
Air cleaner element tapping screw:
1.1 N·m (0.1 kgf·m, 0.8 lbf·ft)
Air cleaner lid tapping screw:
1.1 N·m (0.1 kgf·m, 0.8 lbf·ft)
[3]
[2]
[1]
[3]
[2]
[1]
[4]
[2]
[1]
MAINTENANCE
[1]
[2]
[5]
3-5