Fitting Of Electric Devices; Particular Risks - HAKO Citymaster 90 Instruction Manual

Safety information
pair one on a rim. Always go to a pro-
per workshop for work on tires and
rims because they have specially
trained personnel and special safety
tools.
• Do not carry out any welding, drilling,
sawing or grinding work on frame
parts. Damaged parts may only be
replaced by specialist workshops ap-
proved by Hako.
• Only use original fuses. Using fuses
which are too powerful could dama-
ge the electrical installation and lead
to fires.
• Always disconnect the negative pole
of the battery when working on the
electrical installation.
• Any fluids (fuel, hydraulic oil) esca-
ping under high pressure can pene-
trate the skin and cause severe
injuries. Seek medical attention im-
mediately in order to prevent the risk
of infection. Take care when draining
hot oil - risk of burns.
• Subject the brake system to a tho-
rough inspection regularly! Adjust-
ments and repairs to the brake
system may only be completed by
specialist workshops approved by
Hako or recognized brake service
workshops.
• Subject the hydraulic system to a
thorough inspection regularly! Adju-
stment and repair work on the hy-
draulic system may only be
performed in specialist Hako work-
shops.
• It is absolutely essential to fix the ar-
ticulated steering with the locking
strap before being loaded on a ve-
hicle or trailer for transport or for
maintenance and repair work, refer
to Section 5.4.

1.4.1 Fitting of Electric Devices

The machine has been equipped with
electronic parts and components whose
function may be influenced by electro-
magnetic radiation of other systems.
Such influence may involve personal
hazards if the following safety
provisions are not complied with:
Before subsequent fitting of electric or
electronic devices and/or components
connected to the on-board system, the
user is responsible to check whether
the installation causes interferences
with the vehicle's standard electronic
circuit or other components.
In the first place, make sure that the
subsequently fitted electric and
electronic components comply with the
applicable version of the EMC
regulation 89/336/EEC and it revisions
and be marked CE.
The following requirements have to be
met in addition when subsequently
fitting mobile communication systems
(e.g. transceivers, mobile phones):
• Fitting of devices with approval by the
applicable national authorities (e.g.
for Germany the BZT licence) is ad-
mitted only.
• The items have to be installed in a
firm place.
• Use of handheld or mobile systems
inside the vehicle will require firm in-
stallation of an external antenna.
• The transmitter module is to be instal-
led in adequate distance from the ve-
hicle's electronic circuits.
• When installing the antenna, esta-
blish a good contact between anten-
na and vehicle ground.
1.5

Particular risks

Safety equipment
• Never operate the Hako-Citymaster
9